L298N Motor Drive Controller Board Module dual H-Bridge DC Stepper Motor Driver for Arduino Raspberry Pi Smart Robot Car
To avoid damage the voltage stabilizing chip, please use an external 5V logic supply when using more than 12V driving voltage.
Use large-capacity filter capacitors and diode with freewheeling protection function, increasing reliability.
Our motor regulator board drive voltage is 5V-35V, drive current is 2A, max power is 25W.
Large capacity filter capacitance, afterflow protection diode, more stable and reliable.
Logic voltage: 5V
Logic current: 0mA – 36mA
Storage Temperature: -20 ℃ to ℃ to + 135
Operating mode: H-bridge driver (dual)
Drive voltage: 5V – 35V
Drive current: 2A (MAX single bridge)
Maximum power: 25W
Dimensions: 43 x 43 x 27mm
L298N as main driver chip makes strong driving ability/small heating/strong anti-interference
Use large-capacity filter capacitors and diode with freewheeling protection function, increasing reliability
This module integrated with one internal 5V power supply, meaning when your driving voltage is 7V-35V, it makes 5V of energy board power supply logically; when 5V of energy board power on, please not input voltage to +5V power supply in interface but you can lead 5V voltage for external usage.
Eg: ENA enable IN1 IN2 to control OUT1 OUT2
ENB enable IN3 IN4 to control OUT3 OUT4
2 x L298N Module